Case Pavo20 Pro and Pro II for Dji O4

I updated the V2 version of the previous case, the lower part I only changed the writing, the size is always the same, the central drawer has been completely modified to accommodate the O4 Pro, it attaches as always from behind via a protrusion that I created, and rests precisely on top of the battery compartment, the lid has remained unchanged and the closure too, I inserted the entire case into different plates so you will have all the pieces available.

I wanted to create a case with an elegant yet captivating design, with sinuous curves that are both pleasing to the eye and to the touch. I was very careful to eliminate almost all visible edges and make them much more rounded. I hope you like it; if you print it, let me know what you think in the comments. Best regards.

Assembly material:

Hinges: 2 screws m3x20 and nut

23-6-2025
Update
I modified both the closure and the attachment for the closure, it had problems with the holding, I redesigned the holes on the top cap, now the closure is perfect, print only the closure of the case at 80% to have greater resistance, so there is no risk of breaking it during assembly.

Whoever printed the old closure with the relative case cover is asked to print the new one.Thanks

16-11-2025 Update:

The internal drawer has been overhauled and slightly lengthened by 2mm. It had a small defect when inserted into the box; as soon as it was moved, it would fall inside, resting a few mm on the internal surface. It is now thicker and sits better inside the case.

In addition to the internal drawer, I dug into the top cover where the DJI O4 antennas were bumping and pressing them inward. Now they have a space where they can be positioned easily without any kind of stress.

You can also add the take-off base to the case, which you can print as you like (I printed it red so you can see it everywhere), you will always find it on my page