Search models, users, collections, and posts
AR15 PMAG M2 + M3 Dust Cover no supports
IP Report
Print Profile(2)
0.2mm layer, 3 walls, 100% infill
Designer
9.9 h
2 plates
0.12mm layer, 2 walls, 15% infill
5.2 h
2 plates
Open in Bambu Studio
Boost
329
1252
72
33
735
525
Released
Description
New design that fits both M3 and M2 PMAGs. Huge thanks to @CodfishDan_1930853 for helping me tweak the model to fit M2 PMAGs!
Dust Cover for MagPul AR15 M2 + M3 PMAGs. Optimized for printing. I was able to get rid off all but one overhang, but a well calibrated machine can handle the small remaining overhang easily without supports.
Versions available:
- v5: standard version
- v5 LT: removed as much material as possible but therefore not as much surface on print bed. if you have issues with adhesion, use v5 instead
- both versions have a lanyard loop for paracord
Recommended Print Settings:
- print on side (file is oriented correctly)
- 0.15 or 0.2mm Layer Height
- no supports needed
- 3+ Perimeters
- 100% Infill
- PETG
Local laws apply
If you need anything, feel free to reach out! Questions/Suggestions/Criticism is highly appreciated. Happy Printing…
[Desciption may include amazon reflinks]
Boost Me (for free)
if you like my design, feel free to give me a boost :)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (72)