Search models, users, collections, and posts
"Bradford" dining chair 1:12 scale
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
37 min
1 plate
Open in Bambu Studio
Boost
87
212
17
0
121
92
Released
Description
1:12 scale to the original design.
Chair is divided into two objects so that that legs can be printed without support by turning them upside down on the plate. Seat/Chair back requires support - I used tree supports (auto). After printing, it's easy to align the two pieces and join with some glue.
The top and bottom of the upper rail of the chair is a bit rough due to how the layers print - if anyone can figure out how to smooth them, I'd welcome the suggestion! (I imagine that printing in smaller height layers - such as 0.12-0.16mm - would be helpful).
I created this model with MakerLab from a picture on the Pottery Barn website.
Powered by Image-to-3D from MakerWorld (https://makerworld.com/makerlab/imageTo3d)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (17)