Senseo Pad Holder

This 3D-printed holder is specifically designed for Tchibo and Senseo coffee machine pad holders. It accommodates two pad holders, inserted upside down for easy and hygienic drying after use.

Special Features:

• ✅ Suitable for Tchibo/Senseo pad holders (single and double-cup inserts)
• ✅ Efficient drying: The pad holders are inserted upside down, allowing water to drain.
• ✅ More order: Both pad holders have their designated place – no searching, no clutter.
• ✅ Space-saving: Wall mounting directly next to or above the coffee machine.
• ✅ Attachment with suction cups: The back features threaded inserts for two or four suction cups, suitable for smooth surfaces (e.g., tiles, glass).
• ✅ Alternatively: Mounting with strong double-sided adhesive tape is possible.

Assembly Instructions:

• No direct screwing intended.
• The back features M4 threaded inserts (e.g., ruthex M4) for attaching the suction cups.
• Compatible with suction cups Ø30 mm with M4 thread.
• Two suction cups are usually sufficient – four increase the holding power.

Required mounting material (not included in the print):

• 2–4 x suction cups Ø30 mm with M4 thread
• 4 x ruthex M4 threaded inserts (already installed or to be installed later)
• Optional: strong double-sided adhesive tape as an alternative fastening

Recommended printing material:

• PETG or ASA for water resistance in the kitchen
• PLA only recommended in a dry environment