Kindle Paperwhite 10th gen 6" Two Finger Grip - Free 3D Print Model

Search models, users, collections, and posts

skarl

Tools>Gadgets

IP Report

Print Profile(1)

All

P1S

A1 mini

H2D

X1 Carbon

P1P

X1E

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 2 walls, 15% infill

Designer

34 min

1 plate

4.7(21)

Open in Bambu Studio

Boost

163

337

226

Released

Description

One-piece, no assembly required friction fit two-finger grip for holding the Kindle Paperwhite (10th Gen) comfortably.

Likely fits other e-books with height of 167mm.

Model has rounded edges from the side you would normally put your fingers through holding the e-book righthanded, while the edges on the bottom side are not rounded to ensure a simple and consistent print. Fingerholes have rounded edges on both sides, but require no supports.

Finger holes are 23mm in diameter.

Print profile in PETG, but likely prints just fine in other materials like PLA.

Comment & Rating (24)

@alias

Print Profile

0.2mm layer, 2 walls, 15% infill

Perfect print Ultra practical for long reading sessions

Show original

@user_3619374085

Print Profile

0.2mm layer, 2 walls, 15% infill

Upscaled to fit my kindle Paperwhite Signature Edition (11th gen) and it works perfectly sans case. Thanks for sharing your file! :)

@RichterV

Print Profile

0.2mm layer, 2 walls, 15% infill

Super useful, but the tolerance are quite tight, scraping the side of my kindle. Nonetheless useful print!

@ximaxima

Print Profile

0.2mm layer, 2 walls, 15% infill

Not sure why but it was too tight on my device

@user_1006559134

Print Profile

0.2mm layer, 2 walls, 15% infill

This helps prevent hand fatigue and I appreciate you sharing your design. Thank you!

@nkrctnbjm

Pros: Strong, comfortable, fast print. Cons: Edges too sharp, should be slightly bigger for the 10th gen Kindle, I scratched up the rubber edge a little bit trying to get it on/off. I took a little bit off with a file and now it fits great.