An improved, easier-to-use manual filament drying bin! The most convenient operation method for bucm two-handed use! Drying bin stand!

I recently purchased a set of bmcu; previously, I used a drying box, but I always felt it was inconvenient to change materials. Combining various drying boxes online with my ideas, I completed this drying bin with manual material discharge. When changing materials, it's extremely convenient to hold the bmcu clutch with one hand and rotate it with the other; material discharge is also quite fast. Multiple central shafts can also be printed to avoid the trouble of repeated disassembly and installation. The overall airtightness is also excellent. After adding desiccant, it can be maintained in single digits, as shown in the figure!

Except for the drying bin, no other metal accessories are needed; only a 5.5mm drill bit is required. Drill a hole on the drying box where the rotating shaft extends in. I made an auxiliary board; simply stick the auxiliary board to the top with double-sided tape, drill a circle of holes with a drill bit, and then cut it off with a small scraper!