Search models, users, collections, and posts
Bed slat end cap
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 35% infill gyroid
Designer
49 min
1 plate
Open in Bambu Studio
Boost
15
28
2
2
79
56
Released
Description
Content has been automatically translated.
I needed end caps for the slats of my Gautier bed.
They tend to break: probably due to the reduction in material used to save a few cents.
I couldn't find what I was looking for on MakerWorld so I created my own.
The spacing between the lugs is 38 mm. This part can accommodate slats 55 mm wide and 9 mm high.
I used PETG for printing for better resistance/flexibility.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)