Macbook Magsafe Charger Cord Organizer
Print Profile(1)
Description
This custom-designed cable organizer is made to perfectly fit the 30W Apple charger (Model A2164) that comes with many MacBook models. It helps keep your charging setup tidy by allowing you to neatly wind the cable around the charger, preventing tangling and wear. Snug tolerance fit onto charger that doesn't scratch the charger.
The organizer consists of a main frame and two cable guides (the side ridges) which must be glued into place. These guides snap into the side slots and are easily secured with a small amount of superglue. Once attached, they hold the cable firmly and allow for compact, clean storage.
Assembly Instructions:
- Slide the two cable guides into the side grooves on the main frame.
- Apply a small drop of superglue to secure each guide.
- Let the glue dry fully before use (recommendation: at least 5 minutes).
- Plug in the charger and wind the cable around the organizer for clean storage.
Printing Details:
- Print time: ~1 hour 10 minutes
- Supports: Not required
- Recommended orientation: Flat on the back for best surface finish and strength
- Layer height: 0.2 mm
- Infill: 15–20% is sufficient
Compatibility:
- Apple USB-C 30W Power Adapter
- Model number: A2164
Notes:
- Only a minimal amount of glue is needed.
- Not compatible with other Apple charger sizes (61W, 96W, etc.).
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (6)