Motorola T82 Charger Wallmount
Print Profile(1)
Description
Motorola T82 Charger
- for use with two Motorola T82 radios
- devices charge via USB
- bottom open for potential carabiners on the radios
The file includes four holes for pogo pins and an additional hole for the USB cable
The USB cable must be soldered to the pogo pins (!!!observe polarity!!!)
- Press the pogo pins into the designated holes, ensuring only the spring tip protrudes
- Then feed the USB cable through the side hole from the outside
- Solder the USB cable to the pogo pins (PLUS/MINUS)
- Test if the spring contacts function correctly and the radios charge
- Finally, adhere the rear cap
Here is an example of the required components I used:
Pogo Pin
USB Power Cable
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)