micro drip x-split-reduction

Small adapter/reduction for micro drip watering systems. Leads trough a ½'' (13mm) and split off two 3/16'' (4.6mm).

I use this in my micro drip system with 1.5 bar. I din't test it with higher water pressure.

For those low pressure it works fine without o-ring seal. But I prepared a grove if you want to add a o-ring.

Due to the gemometry it barely need print support structures. I recommend light colored PETG due to water contact and outdoor use.

I also designed micro drip sprinklers, which are connected to the 4.6mm outlet:  https://makerworld.com/en/models/1449736-low-pressure-garden-bed-irrigation#profileId-1536253