Odin2 portal case

Hard case for “Odin2 Portal” handheld. Printed in Matte PLA, and the insert in TPU. My printer is not big enough to print it laying flat, so it was printed in an upward angle. Because of that it bowewd a little but it is still usable. I I printed again I would use lower bed temp or even better i would print in PETG. The hinges / locks are attached by filament. The holes for the filament are a little tighter than i would like but it worked at the end. The original model was used as a general inspiration and for the hinge / lock design that I like very much. Besides that it is very different from the original model.

Edit: Reprinted in PETG on the side diagonally on the bed and it came out great.