Ringu Q-Version Sadako Fridge Magnet Figurine

I enjoy contrasting elements, so I thought I'd design a Sadako-themed fridge magnet. The most memorable scene featuring Sadako is her emerging from the television, but a realistic portrayal would be rather frightening. So, I input the prompt into ChatGPT-4, which generated the following image:

I found it quite charming, and then proceeded to generate a 3D model sketch, as follows:

The fidelity is quite high, but it felt a bit too cute. So I further refined the prompt. In my memory, Sadako's face is always partially obscured by her long hair. Hence the following draft:

This aligns perfectly with my vision: not overtly frightening, yet incorporating cute elements. I then imported this model image into an image-to-3D-model website, exported the model, and refined it further in Blender. This resulted in the current version. I printed a white prototype, and the result was quite pleasing, as shown below:

To facilitate support removal and ensure a relatively clean model surface, I adjusted the model orientation. There will be some supports, especially in the hair, that may be slightly difficult to remove; however, slow and careful removal should yield clean results. Subsequently, I painted it, referencing the image provided. Acrylic markers are somewhat thick, and my skills are limited, resulting in a somewhat hastily applied paint job. The effect is acceptable from a distance; I am certain you could achieve a far more polished result.

I also incorporated two 6x3mm magnet recesses on the back of the television. Feel free to adjust this to accommodate the size of your magnets. Alternatively, feel free to scale this up to make a charming desk ornament. I hope you enjoy it.