WHQ - Old Rope Bridge
Print Profile(1)
Description
YOU SHALL NOT PASS ! !
Boost Me (for free)
If you like this please send me some love---and a boost
This can be a stand alone piece of terrain. (well you would want to have a river/creek, hole, crevasse or chasm you would want to cross first)
It intended this to be an accessory to my line of WHQ (war-hammer quest) that I'm building. but i figured it was good enough to publish on it's own.
it is setup for 25mm or 33mm (or anything if you just change the sizing)
it is approx. 105mm x 50mm x 40mm (LxWxH)
or in inches for our American friends
4 1/8" x 2" x 1 9/16"
I have made some boards for this and notched the ends to sit better on the rope. you can customize it as you want and glue in place or change to suit your wants/needs
I'm not sure I'm done with this model yet as there are some things I still would like to do (try) but it fits my current needs and I have a lot of work on the other board pieces yet
The settings on this for supports are default. It was a bit of a pain to take them off but if you know more about the settings please feel free to adjust. This is a rope bridge and I feel if there are little bits hanging from the bottom it will actually enhance the look and make it look worn
This was printed on Bambu PLA Matte Ivory White using a .4mm nozzle. layer line was set at .1mm. I think it would look better on a .2mm so go for it. I have been experimenting with setting the .4mm down to .08mm. It gives a warning but it prints fine.
I hope you enjoy
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (7)