Search models, users, collections, and posts
ToolPro Edge - Gridfinity base.
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
6.6 h
5 plates
Open in Bambu Studio
Boost
8
8
0
0
8
3
Released
Description
Measured and set up a layout to adapt the Gridfinity range to my Toolpro toolbox.
The grid layout was created using the Gridfinity tool; This is just a quick print option for those with the ToolPro range who want to start deploying Gridfinity.
The drawers are 550mm wide and 410mm deep.
The depth limit for boxes in these drawers is 45mm.
This setup is for a single drawer (of which the ToolPro 51" chest has 8 of)
Printed with PLA, 0.4 nozzle.
Layout ideas and boxes will be uploaded as I figure it all out.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)