Search models, users, collections, and posts
AR FIBER LASER ENGRAVING JIG FIXTURE, LEFT HAND AND RIGHT HAND
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
3.9 h
1 plate
Open in Bambu Studio
Boost
31
58
0
0
104
22
Released
Description
These fixtures are for holding your AR receiver on a fiber laser engraving table. Keeps the frame level and repeatable for multiple engravings.
Holes are 6.2mm for most common beds. The spacing is 25mm along the long edge and 75mm along the short edge. This should adapt to most beds hole spacing. I put extra holes in to help line up under the center of your laser.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)