Search models, users, collections, and posts
30mm radial 4g antenna holder
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
30 min
1 plate
Open in Bambu Studio
Boost
1
7
1
0
13
8
Released
Description
Printed for holding 4g antenna, the base of the antenna is 30mm.
This should clip quite snugly. Printed in PLA and used double sided 3M tape to hold in place as I didn't wanted to make more screw holes.
For printing: make sure that the model is upside down (check the picture). Removing supports should not be difficult.
Boost Me (for free)
If by any chance this was useful for you and you want to boost me - thank you.
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (1)