Summary

The push fitting on the cable clip of my Vax Steam mop snapped so I have designed a quick little print to replace it.

Print Settings

Printer Brand:

MakerBot

                                            Printer:                      
MakerBot Replicator Dual

Rafts:

Doesn't Matter

                                            Supports:                      
No

Resolution:

0.2mm

                                            Infill:                      
10%

Filament: ERYONE PLA
Orange

                    
                        Notes:                     
I used PLA becase thats what I had on hand. I'm sure it would work just as well with other filament types.
I also printed with an 8mm brim - but I dont think this is nescassary.

Post-Printing

I'd advise printing with some support material to get a nice straight edge on the actual clip lugs, so the only real post printing action would be to remove the support material.

cableguide

steammop

vax