Dragster V2 (wheels spin!)

Here's the V2 dragster!

This enhanced version boasts rotating wheels, transforming it from a mere decorative trinket—as V1 was—into a delightful plaything.

I printed it using PLA Metal and found the results quite compelling (hence its inclusion in the nomenclature).

I explored every avenue to keep the spoiler integrated with the dragster, printing them as a single piece, but to no avail (the spoiler consistently fractured during support bar extrusion). The spoiler is therefore printed separately. Simply adhere it to the support bars using superglue (alignment markers are printed in white on the profile to facilitate precise spoiler placement. Should you prefer to forgo the markers or lack an AMS, simply remove the white in Bambu Studio).

PRINT WITH SUPPORT ON PLATE ONLY! Failure to enable this option will render the supports irremovable, hindering wheel rotation.

I recommend using PETG for the support interfaces (already configured in the profile).

Let me know in the comments if you'd like me to add a (glue-on) driver and/or create a four-color version (sans alignment markers and support material).

CAUTION: To ensure optimal print quality, meticulous printer calibration is crucial, as the front wheel axle is situated very close to the edges. If the wheels fail to rotate, gently rotate both simultaneously until they disengage. I suspect using PETG for the model itself might impede wheel rotation (due to potential filament leakage).