R106 5G CPE Housing

写在前面：这是本人以前在t站上发布的作品，搬运回来存档，介绍详情懒得更新了，大家可以自行翻译一下。

Summary

This is a 3D printed case for R106. Has both active and passive cooling mode. And you can also swap the antennas if you like.
To build this ,you need:
Four M214 screws
Two M26 screws
Six M2 nuts
Three 28283mm heat sinks
One 3007 turbine
One SS-12F15 G5 switch
Three 5cm welded to SMA female (note that the line should be selected with a wire diameter of 1.13 ）
Three 10cm welded to SMA female (note that the line should be selected with a wire diameter of 1.13 ）
(Pay attention to the inner pin or inner hole of SMA, I personally choose the female inner hole and the inner pin antenna)

(Actually, you can also choose to use six 10cm welded to SMA, that would made the cable management process a lot easier)

Print Settings

Printer: 

P1P

Rafts:                      

Doesn't Matter

Supports: 

Yes

Infill:                      

40% or more

Filament: doesn't matter ABS
any thing you like