hwd37(w06) housing

写在前面：这是本人以前在t站上发布的作品，搬运回来存档，介绍详情懒得更新了，大家可以自行翻译一下。

Summary

This is a 3D printed case designed for the HWD37（w06） motherboard.
To build this ,you need:
Four M214 screws
Four M2 nuts
8040*5mm heat sink
3 4G patch antennas (these three antennas may need to adjust their own length, too long to hide in the shell) (and don't buy too big antennas!)
Two 5m welded to SMA female (note that the line should be selected with a wire diameter of 1.13mm）
Two 10cm welded to SMA female (note that the line should be selected with a wire diameter of 1.13 ）
(Pay attention to the inner pin or inner hole of SMA, I personally choose the female inner hole and the inner pin antenna
754793 lithium battery (note that it is a 4.35V high-voltage lithium battery, because the original battery is 4.35V)
One power cable with 10k resistance

Print Settings

Rafts: 

Doesn't Matter

Supports:                      

Yes

Infill: 

40% or more

                Filament: doesn't matter any thing you like