Star Wars Imperial Star Destroyer

The Star Wars Imperial Star Destroyer, now in ready-to-print mini version! This print is designed to be handled by .2mm diameter nozzles, and should be scaled up as needed if you want to print it with a .4mm nozzle. At 100% size, it is 55mm long, 26mm wide, and just over 18mm tall, making it around the size of a USB drive. I gave it supporting feet so I could use it as a replacement ship in board games, and I will probably upload a version without feet and one with stand at some point.

For best printing results, I found that this model should be printed on its engines with supports, and if you print the STL, supports should be negated in the engine area and around the two extreme engines as pictured below. This is to keep the supports from encasing the three main engines and pulling the engines out when removed. 

I used the .08mm High Quality preset of a .2mm nozzle in Bambu Studio to produce the version pictured in the thumbnail with tree supports (auto.) The entire print takes about one and a half hours if everything is made of one material, however Bambu Lab's Support for PLA material leads to MUCH higher print fidelity, but also a roughly ten hour print time.