Search models, users, collections, and posts
Reinforced Bow (Only 11g)
IP Report
Print Profile(1)
0.12mm layer, 6 walls, 15% infill
Designer
39 min
1 plate
Open in Bambu Studio
Boost
6
10
0
0
7
3
Released
Description
Content has been automatically translated.
Boost Me (for free)
The reinforced bow has arrived!
- Upgraded form, enhanced elastic deformation, increased power!
- The launch port is centered; it is recommended to hold it horizontally as shown in Figure 2 for launching; if held vertically, the arrow will point downwards.
- Due to bridging, you may need to clean the launch port with a small knife after printing.
- It is recommended to use PETG filament; only 11.25g is needed.
- The string can use mask straps, tighten and knot for a good effect.
- Never aim at people when launching; children must exercise caution when playing!
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)