The Coleman Cubby

A cubby/storage pocket for the Coleman RB/RT200 and B200R/C/V.

Should also fit MegaMoto 212.

There are 3 versions of differing depth.

All versions are fixed in place with zip ties and feature a drain hole on the kickstand side.

The file I posted is for PLA but I highly recommend printing in a filament with higher temp resistance. Especially if you have a stock muffler as it radiates quite a bit of heat upwards. The one I made for my bike is ABS-GF. 

Tray: The easiest to install and shallowest. Pops into place without removing the seat and clears the bottom of the frame rails to give the most clearance for whatever mods you may have.

Cubby: Medium. Must remove seat for install. Clears top of fuel tank if you have an engine lift plate installed.

Bin: Deepest. Must remove seat for install. Clears top of fuel tank on a stock bike.

I plan on making more versions for phone mounts, keyed ignition, etc. when I get more time. Including a Hell Yeah version to hold a beer can.