Mavic 3 Pro Filter and TF Card Case
Print Profile(1)
Description
Boost Me (for free)
If you find this useful, please consider boosting me! Thank you~
This storage box accommodates four ND filters, one wide-angle lens, four TF cards, and one SD card.
It is recommended to 3D print the liner using TPU. Due to tolerances inherent in different printers and filaments, the storage cards might fit too loosely or too tightly. This can be addressed by slightly adjusting the X-Y dimensions of the holes.
During assembly, insert the slider into the back of the liner, then press the liner into the outer shell until it is completely flush (take care not to dislodge the slider while pressing in the liner).
The text on the liner is recessed and requires pen filling after printing.
For enhanced durability, it is recommended to use a small number of metal fasteners at the pivot points, as follows:
M2x35mm Pan Head Screws *2
S-M2 Rivet Nuts *2
*If you dislike the text on the card holder, you can remove the “text” objects in your slicing software.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (10)