Pac-Man Magnet Set 6x3mm

Hope you enjoy this Pac-Man Magnet Set. I was searching for something that worked well for me and didn't find a single set with everything I wanted, so I created my own. 

I chose to include 9 left looking and 9 right looking ghosts, 9 Pac-Man, 20 eyes for the ghosts (pre-colored for no hassle AMS printing) and 16 frightened ghosts. Why that quantity? I have no idea. Actually, I chose to print 9 sets of ghosts in the original red, pink, orange and blue, along with the pac-man, to give away as gifts. But then decided I wanted to give 4 of those people 4 frightened ghosts too, so yeah… I ended up with this quantity. Delete what you dont need and enjoy. 

These use 6x3mm magnets. I worked hard to get the sizing right, so the magnets will fit, but stay in place. 

***Be warned, it can be hard to get the magnets inserted, but that's by design. I found the best way to get them in was to stack a few magnets together, about 5-6 high, and use something flat to push the magnet into the hole. However, your printer may print slightly different than mine, so it's never a bad idea to print 1 piece and test it. If it's too snug, increase the object size by 2-3% a try again. You could also use a very quick blast from a lighter to slightly soften the plastic, but you then had to be extra careful not to move the magnet and stretch the hole too wide. 

For those with 5mm wide magnets, you should be able to reduce the size of any of these to 5mm high, making sure to leave “Uniform Scale” selected, and that should fit a 5mm magnet instead. Again, print one and test it first. 

Big props to Yasiek https://makerworld.com/en/models/1262515-pac-man-ghost-magnet?from=search#profileId-1287481 as his model was a big inspiration. Go check his out and give him some love. 

Happy Printing!