Ultralight Magnetic Shelf Divider 165 x 55 mm

Magnetic shelf divider optimized to use the bare minimum amount of filament and print quickly. At 15.09 grams of material per they pack a lot of punch for a light model. 

Feel free to tweak the print profile, but my attached one uses a single wall and .28mm layer height to speed up the print and minimize material usage. This is a long slim model, so some form of bed adhesive may be needed if you experience warping, but at the low infill it usually isn't a problem. The second print profile fits a full plate (for x and p series printers) with 19 dividers!

Note: there are overhangs but they are filled by magnets in assembly, no supports are needed.

Assembly: place a small drop of your preferred adhesive into the holes on the bottom of the print and add one 10x3mm magnet to each hole. 

Feel free to use and sell to your hearts content (but if you are making money at least send some boosts my way, deal?) 😊😊😊