Tabletholder for CFmoto 450MT + Oukitel RT3 Pro - Free 3D Print Model

Search models, users, collections, and posts

TS-Design

Hobby & DIY>Vehicles

IP Report

Print Profile(1)

All

X1 Carbon

P1S

X1E

H2D

P1P

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 6 walls, 25% infill

Designer

4.1 h

1 plate

5.0(2)

Open in Bambu Studio

Boost

Released

Description

This tablet holder is designed specifically for the CFMOTO 450MT and fits the Oukitel RT3 Pro perfectly. It may also be compatible with other motorcycles and tablets, but this cannot be guaranteed.

The inner part of the V2 holder is a separate component. I chose to make mine out of aluminum, simply because I had the means to do so. However, it should work just as well when 3D-printed.

Version 1 (V1) offers a secure and stable mounting solution. Version 2 (V2), on the other hand, is designed for quick and easy use—allowing you to mount and remove your tablet in no time.

To improve stability, I added a small piece of 2 mm foam underneath the V2. This helps prevent the tablet from sliding side to side and applies gentle pressure on the latch mechanism for a tighter fit.

Required materials

Spring Pin, 5mm diameter, 70mm length
(https://www.aliexpress.com/item/1005006113357113.html?spm=a2g0o.order_list.order_list_main.4.22781802aFPtEX)
Rod, 2mm diameter, cut to 60mm length
(https://www.aliexpress.com/item/1005005477259278.html?spm=a2g0o.order_list.order_list_main.12.22781802aFPtEX)
Heatinsert M2
(https://www.aliexpress.com/item/1005003582355741.html?spm=a2g0o.order_list.order_list_main.52.22781802aFPtEX)
M2 screws
2x M2x6mm for tabletholder V1
1x M2x5mm for tabletholder V2
4x M5x15mm - Countersunk screws
2x M5x20mm - Cylinderhead screws
6x M5 Nut
2mm thick foam (Only necessary for V2)

Assembly instructions tabletholder V1

Carefully remove all support structures from the printed parts.
Press two heat inserts into the Brace V1.
Attach the brace by screwing two M2 screws through the Tablet Holder V1 into the brace.
Mount the complete holder onto your motorcycle.
You're ready to go – have fun!

Assembly instructions tabletholder V2

Carefully remove all support structures from the printed parts.
Cut the rod to a length of 60 mm.
Insert the rod into the side hole and slide it through Brace V2.
Press one heat insert into the side hole of the Tablet Holder V2 to secure the rod.
Mount the complete holder onto your motorcycle.
Enjoy the ride!

Dimensions to check if it fits with other tablets
Height: 135mm
Depth: 14.5mm

Dimensions to check if it fits with other bikes

Bardiameter: 22mm

Offset from bar (variable): 53mm - 63mm