HEADLESS Print in place Pwnagotchi

This updated model is for HEADLESS use (i.e. no display hat), but with the exposed GPIO version, there's some versatility.

Requested by Lilkideminem on Printables.com, I give you the headless version of the print-in-place case!

I have made some changes to the IO ports on the case, now allowing easy access to the mini-HDMI :)

Just like the original, this model is print-in-place, but this comes with the stipulation that your printer MUST be able to bridge at least 20mm without tons of drooping. This is vital for successfully printing the hinges, buttons, and latch receiver.

There are four variants:

1. Ventless - Stealth pwning at its finest 

2. 14x14mm Heatsink - For people who might use the device for heavier computational tasks requiring additional cooling (but for pwning, it's more than fine leaving the silicon bare or using a low profile copper sheet sink).

3. Vented -  Provides peace of mind knowing their little Pwnagotchi pal isn't asphyxiating.

4. Exposed GPIO - For those want to run headless most of the time but may occasionally add the screen back or need the GPIO pins for other things. The design has been changed so there is a 0.2mm sacrificial layer; this keeps the housing “sealed” until adding headers is desired. There is also a space for the 8-pin connector in the lid so the display hat sits flush. (See images with white housing)