Flylens85 Camera Protector Canopy/Frame v1.6.1

Approx 5g in weight, but will help protect your air unit. I've been using PETG as it's rigid and the slight flexibility helps to install the part. Slide in the front area as much as you can (might have to push down on the camera holder a little bit during install for clearance). The back two clips should be able to hook around the frame once pushed all the way back. 

Whats new in v1.6.1?

Removed lower half of the camera frame circle. I thought it visually looks nicer with the full circle, but I determined it was unnecessary because the built in prop guards protect that area of the camera already. The frame was made thicker and the support beam across the top has been made wider. 

The downside is that at higher camera angles the frame is visible on the top corners of the camera feed. I may make another version where the frame doesn't stick out as much to avoid this issue. These are cheap prints and expect PETG to break upon a strong impact. The TPU I have is too flexable for me to feel confident it'll protect the camera. So it's my backup in my camera bag just in case I run out of PETG ones in the field.