Stanley Powerlock 25' Tape Holder Multiboard

Buy me a coffee? https://buymeacoffee.com/practical3dp 
This holder is designed to work with this tape measure: https://amzn.to/3Lqkt1I (Amazon affiliate link)

READ ME: This holder is specifically made to fit the Stanley Powerlock 25' which looks like the one in the pictures. I cannot guarantee fitment unless you use the exact same tape that I have.  It may work with other tape measures, but fitment is going to be as exact. The dimensions of my measuring tape is 77mm x 44mm

Stanley Powerlock 25' Tape Holder Multiboard

Easily slot your Stanley Measuring Tape into this holder. Attaches with two built-in flush moderate weight-bearing snaps and two regular flush snaps. I included two profiles, one for PETG and one for PLA. I preferred PETG. 

After the print finishes, remove the supports with pliers. Then use a razor blade to clean up the bottom edge of the snaps for good fitment in the multiboard.

PRINT INSTRUCTIONS:

Print with .12 layer heights, 10-15% infill and 2-3 walls for best results. Lower layer heights create a smoother finish for the curves on the part. .16 or .2 layer heights will work fine aswell. Manual grid supports should be used underneath the snaps on the back. 

LICENSING: You may not use this design or file for commercial purposes. See Full License Here: https://www.multiboard.io/license
Creative Commons - Attribution - Non-Commercial - Share Alike

Original Designer: https://thangs.com/designer/Multiboard