Washer / Riser Stumblor Splitter + Stern Spike2

These washers allow your Stumbler power Splitter+ for Stern2 Pins to be slightly elevated from the side cabinet just enough to where the contacts on the back of the board do not hit.  From the Stern factory the holes used to mount the original cable brackets can and often will be at an angle causing the Stumbler board to deform and bend severely into the cabinet when tightening the screws. These washers help mitigate that issue, but when installing the operator should pay close attention to avoid unnecessary over tightening. 

If the play field alignment bracket on your machine is directly behind the board, remove both screws and lift the bracket up 1 bolt hole. You will now only have 1 screw on the bottom of the alignment bracket unless you choose to re-drill the top. 

The printed washers will fit snugly around bolt threads to aid in install.