Corne 4.1 Angled Bottomplate
Print Profile(1)
Description
Angled corne 4.1 bottom plate.
- Angle is about 3 degrees.
- Recessed areas for silicone feet (8mm).
- Screws for board mounts are inset to allow for the same m2 screws that are part of the build guide on github.
- Print is shown above with the silicone feet because I assembled before taking photos. I included a render though to show the recesses for the feet.
Printed at extra fine or 0.08mm layer height to minimize angle steps on final print. I meant to print on the smooth plate, but forgot to swap it out. I would recommend the smooth plate over the textured plate to ensure that the standoffs are mounted flush. In my print, this ended up not being a problem.
License
You may create derivative works based on this object, provided that all such derivative works are published exclusively on the MakerWorld platform and include proper attribution to the original creator. You may not share, upload, host, distribute, or publish this object—or any derivative work of this object—on any other digital platform, marketplace, or distribution channel. Commercial use of this object and any derivative works is strictly prohibited. This includes, but is not limited to, selling, renting, sublicensing, or using the object in any context in which you receive monetary compensation or other financial benefits.
Comment & Rating (4)