Flush Cutters Holder Multiboard - Snips - Pliers

Buy me a coffee? https://buymeacoffee.com/practical3dp 
These are the wire cutters I designed the holder for: https://amzn.to/3LtL5Pm (Amazon affiliate link)

Bolt Locked Flush Cutters Holder For Multiboard (REMIX):

I created a holder which bolt locks into the multiboard to hold your flush cutter/wire snips. I included print profiles for PETG and PLA. I prefer PETG. 

To use this holder, print it, then use a multiboard snap of your choosing and locking bolt found here:

Heavy weight bearing snap: https://than.gs/m/1311032?image=2135387

Moderate weight bearing snap: https://than.gs/m/1311034?image=2135390
Folded locking bolt: https://than.gs/m/1310061?image=2134523

Update 10/23/25: Added additional versions ranging from 10mm to 30mm hanger depth to accommodate other tools 
 

PRINT INSTRUCTIONS:

Print with .12 layer heights, 10-15% infill and 2-3 walls for best results. Lower layer heights create a smoother finish for the curves on the part. .16 or .2 layer heights will work fine aswell. No supports required.

To create this, I remixed and borrowed the Part B Bolt Lock part from one of the Multiboard parts. I then added the holder to the part, and added filets to create an appealing finish. 

LICENSING: You may not use this design or file for commercial purposes. See Full License Here: https://www.multiboard.io/license
Creative Commons - Attribution - Non-Commercial - Share Alike

Original Designer: https://www.multiboard.io/parts-library