Search models, users, collections, and posts
SSX23 / MK23 TDC Key - stored in trigger guard
IP Report
Print Profile(2)
0.2mm layer, 3 walls, 100% infill
Designer
15 min
1 plate
0.08mm layer, 3 walls, 100% infill
35 min
1 plate
Open in Bambu Studio
Boost
26
56
7
1
71
48
Released
Description
Simple TDC key for SSX23 / MK23
Has been tested on the SSX23 but should fit the MK23 frame just fine.
Print in whatever plastic you like - for me, it was PLA and holds up well, but PETG might be a good idea in the long run.
You will need to cut off around 5mm of your Allen key or any other spare one, and simply push it into the hole. No glue required, but like always might be a good idea :)
I do not recommend cutting more than 6mm, as it might catch on your gloves/fingers from the inside. 5mm seems to be the sweet spot as it sits flush.
The knob is grippy and sized to work with gloves on. It makes contact with the top of the trigger guard first and creates tension on threds so it does not unscrew itself :)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (7)