Search models, users, collections, and posts
Drill Guide Holder for Skadis board
IP Report
Print Profile(1)
0.2mm layer, 4 walls, 7.5% infill, tree supports
Designer
4.1 h
1 plate
Open in Bambu Studio
Boost
3
21
0
1
16
9
Released
Bill of Materials
Bambu Filaments
Select all
Description
Skadis holder for the great drill guide designed by Titan3D here and the fitting bushings here.
I have also included two holes for the Micro Screverdriver Handle by Pilim.
This is my first design using Fusion 360, so it was a bit of a learning curve. It came out great on the first try.
I printed it in PLA with a very low infill or 7.5%. So far it heald up fine, since the drill guides are very light.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)