Beaners

cover

PXL_20250519_133906113.jpg

PXL_20250518_135013606.jpg

Screenshot 2025-05-29 1506092.png

Scupper - Bottom - Use Supports.png

plate_1.png

plate_2.png

Scupper - bottom.jpg

2025-05-17_56e4dca73794e.jpg

Scupper - Top - No Supports.png

Scupper - top1.jpg

Scupper - bottom1.jpg

Scupper bottom.png

<ul><li>PET-G</li><li>Use supports for the bottom scupper mount</li><li>Do not use support for the top mount</li><li>Print at 80% for extra strength</li><li>Use a nylock type nut to avoid it backing off the bolt</li><li>Use a stainless steel (rust) XXmm x 45mm machine bolt</li></ul>&nbsp;<ol><li>Put the transducer wire through the big bell end of the bottom scupper mount and through the scupper in the kayak.</li><li>Put the wire through the small bell end of the top scupper</li><li>Mount the transducer at a 90 degrees to the screw.</li><li>Screw or push the screw end through the scupper from the bottom of the kayak</li><li>Screw the top down mount to secure the transducer - Tighten, but do not over-torque.</li></ol>

0.2mm layer, 2 walls, 80% infill

29MM.png

29mm gap for the transducer mount.

0.24mm layer, 2 walls, 80% infill

Screenshot 2026-06-12 184048.png

Smaller top version (female)80% infill

<boostme><boosttitle>Boost Me</boosttitle><boostcontent>If you find this useful, please boost!  Thanks!</boostcontent></boostme>

Print Profile(3)

Description

Comment & Rating (24)

License

Remixes (1)

Related Models

Scupper Transducer Mount & Passthrough (Pelican)