Search models, users, collections, and posts
Decathlon Bicycle Light/Warning Light/Frog Light/Housing
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
51 min
1 plate
Open in Bambu Studio
Boost
1
1
0
0
4
0
Released
Description
Content has been automatically translated.
The housing of this bike light broke, so to avoid wasting the components, I designed and 3D printed this robot-like housing. The inner diameter of the ring is 24mm; if it's too large, you can cut a few finger parts from nitrile gloves and use them as non-slip thickening pads.
The following parts are needed:
One M3*25 screw, one M5*10 screw, one 15M5 European standard slider nut, and two common self-tapping screws (about 1.6cm in total length).
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)