Adjustable graphic card holder MSI
Print Profile(1)
Description
Min. height 60 mm
Max height 105 mm
You just press the board into the base and it's ready.
Instructions:
I set print by object method because different layer heights and ironing.
Bulid plate 1
Main item + Inner rod
0,16 mm layer height
No ironing
Print by objects
Minimal support only for magnet hole
Brims off. If you need turn on.
Build plate 2
Table
0,2 mm layer height
walls: aranche
Ironing on top surfaces (I set 30mm/s and 30% (I think the correct setting depends on the printer and the type of filament)
Boost Me (for free)
Boost me if you like it! Thank you very much! ;)
An 8x2 mm magnet can be placed in the bottom.
On a flat surface, push the magnet in to make it nice and flat. Minimal superglue can go into the hole, but it's not necessarily necessary.
If you spray a little PTFE or similar lubricant inside the thread, the rod will rotate much better.
If for some reason the thread is tight (although there is really no chance of this), it is recommended to print the rod with a layer height of 0.12.
High-speed printing is not recommended due to fine details.
It probably won't work if resized.
Check out my other uploads and download and print them. ROG, RTX, Aorus, AMD, TUF, and many more.
!!! Make sure the print speed and temperature and cooling are set correctly for your printer and the filament you are using. And the build plate should be clean. !!!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (21)