Search models, users, collections, and posts
Happymodel Crux35 Camera Mount
IP Report
Print Profile(1)
0.08mm layer, 2 walls, 15% infill
Designer
1 h
2 plates
Open in Bambu Studio
Boost
2
12
3
0
22
10
Released
Description
Thank you for using my design! 🎉
If you enjoy this model, please consider liking, boosting, and leaving a review—it helps a lot! For more designs, check out my MakerWorld Profile.
I needed a new mount for my Hawkeye 4k camera and decided to model a new mount for the Happymodel Crux35. I also created a copy of the original mount in case someone needs to replace it.
Print it in TPU for flexibility. I used a very low layer height for a cleaner look and better hole dimensions.
💡 Need Help? Leave me a comment below!
❤️ Support My Work: Leave a like and a comment!
Boost Me (for free)
Boost this design! ⚡ Every boost helps it reach more makers 💡 Quick tip: Boosts are FREE and reset weekly - so why not? 😉
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (3)