Search models, users, collections, and posts
Screw End Cap / Thread Protector M4 - M16 (metric)
IP Report
Print Profile(2)
M4-M9 - 0.08mm layer, 3 walls, 30% infill
4.3 h
6 plates
M10-M16 - 0.16mm layer, 4 walls, 30% infill
2.6 h
5 plates
Open in Bambu Studio
Boost
253
632
58
24
1.2 k
729
Released
Description
Boost Me (for free)
Material
For inside use: any material you like
For outside use: PETG, TPU or ASA
No supports needed.
Recommended layer heights
M4 - M7: 0.1mm layer height
M8 - M9: 0.12mm layer height
M10: 0.15mm layer height
M12: 0.18mm layer height
M14 - M16: 0.2mm layer height
Print orientation
Print with thread down to the printbed and dome up.
Supports are not needed
Consider the use of a brim on the outside
Do you like my work? I would be very happy if you would support my work on Ko-fi.
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (58)