Ring Squirter Prank NO NON 3D PRINTED PARTS < 3H

Fake ring water squirter prank! Completely 3d printed with no extra parts! Less than 3 Hours! Trick and Soak Your friends!

Show you friend your new ring and surprise them with a soaking. Simply fill up the container, place the plunger in, put the ring on and find a friend to trick. Then show them the ring and as they lean in to get a closer look, push down the canceled plunger and soak them!

I printed in PLA, the print profile has supports set up so that they dont get in the way of any mechanisms and are removed easily by hand or with a tool. Spray painted silver as I dont have and filament other than white or grey. I can Imagine It would look super in two or more colors using an AMS, really drawing your friend in before they get soaked!

To ReFill:

1. Take out the plunger and angel the model so that the ring face is higher up than the container
2. turn on the tap and fill the container up to to the top, keeping the model angles so as little water as possible comes out the hole
3. place the ring on your finger, any work its up to you, try to keep the angle so as little water comes out as possible.
4. place the plunger gently in the hole
5. close your hand around the container, ready to compress the plunger when needed.

To get the best effect is worth practicing a few times the angle you hole the ring and how hard you press down the plunger. It does not shoot out a tonne of water but definitely enough to soak your unsuspecting friend!

Here are some of the prototypes for this. I made 4 but chucked the first one as it was so bad.

hope you enjoy!