Search models, users, collections, and posts
Pittsburgh & Shawmut Railroad Coasters & Holder
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
4 h
2 plates
Open in Bambu Studio
Boost
2
5
0
0
1
0
Released
Description
Pittsburgh & Shawmut Railroad Coasters and Holder
These coasters are APROX 101mm x 93mm and 3mm thick.
There are two plates, one with coasters and one with the holder. If you print them and then add a 1mm cork backing they should sit almost flush with the top of the holder.
I always apply a self-adhesive cork backing to my coasters. I have listed a link to them on Amazon. You will have to trim them. https://a.co/d/0PjaF1i
Take a look at my other railroad and non-railroad coasters and clocks at https://makerworld.com/en/@railimages
Boost Me (for free)
Boost Me (for free)
I would appreciate it if you could rate my model and profile and if you really like it, leave a BOOST.
It would be greatly appreciated!
Thank you and enjoy!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)