TSO Parallel Guide holders for Track saws - Free 3D Print Model

Search models, users, collections, and posts

dave3ddiy

Tools>Other Tools

IP Report

Print Profile(1)

All

P1S

X1 Carbon

A1 mini

P1P

H2D

X1E

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 4 walls, 25% infill

1.4 h

1 plate

5.0(2)

Open in Bambu Studio

Boost

167

123

Released

Description

There are three models in here. One to use on the wall in the horizontal position. One to hold the thin rods to use when narrow cuts. Last an end cap to use as a base when hanging up the rods vertically. Model can be printed oriented on its side so you don't need any supports.

Comment & Rating (4)

@paulsizemore

Nice design of a holder.

@bglenden

Thanks for the upload. On my Bambu X1C I had to slightly loosen the fit for the holders with rod (which is the only one I used). This is for a newly purchased TSO parallel guide. In Autodesk Fusion, I widened the track space (i.e., in between the ramps) to 48.8mm (from 48.5), and widened the rod holder diameter to 5.5mm (from 5.0). Probably unnecessarily, I also increased the track holder depth to 11.0mm (from 10.5). YMMV.