Kryptonite U-Lock Dust Cover|Kryptonite Cover

Kryptonite U-Lock Dust Cover / Kryptonite U-Lock Cover

German

The cover is for the Kryptonite U-lock New York M18-WL. This cover replaces the original cover. Under certain circumstances, the cover may also fit other Kryptonite locks, but I cannot test this unfortunately.

I have replaced the original screws with two M3x16mm screws.

Print recommendations:

The cover should be printed from a flexible filament such as TPU. Non-flexible filaments such as PLA and ABS are too brittle and break very quickly during use.

The slider can be printed with any type of filament, I used PLA for this.

=================================================================

English

The cover is for the Kryptonite U-lock New York M18-WL. This cover replaces the original cover. Under certain circumstances, the cover may also fit other Kryptonite locks, but I cannot test this unfortunately.

I have replaced the original screws with two M3x16mm screws.

Print recommendations:

The cover should be printed from a flexible filament such as TPU. Non-flexible filaments such as PLA and ABS are too brittle and break very quickly during use.

The slider can be printed with any type of filament, I used PLA for this.

Print Settings

Printer Brand:

Anet

Printer:

Rafts:

Doesn't Matter

Supports:

Resolution:

0.2

Infill:

Filament:OVERTURE TPU Black