Hueforge Avatar Kaela Mensha Khaine

The project is created from an avatar image, AI-enhanced because its definition was not very good. The enhancement left some visible lines on the image, but they do not hinder the final result.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The model measures 130x200 mm
 

You can print at higher layer heights below the minimum depth of 0.48mm
The maximum depth is 2.24 mm and the actual depth is 2.1mm

Filaments used:
Jayo Black 
Jayo Cherry Red 
Elegoo Yellow 

Jayo White

This print uses 4 unique filaments

Exchange instructions:

 

Start with Black

              At layer #9 (0.8mm) switch to Scarlet Red

              At layer #13 (1.12mm) switch to Yellow

              At layer #20 (1.68mm) switch to White for the rest.