Search models, users, collections, and posts
Pole end centre tool (parametric/customisable)
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
11 min
1 plate
Open in Bambu Studio
Boost
2
8
1
0
10
3
Released
Description
A customisable end cap for any pole tip you need to mark a centre. Note that the print settings are important to ensure the first layer or wall to base looks good.
Printed with Bambu PLA Basic with following settings (on an A1):
- 0.2mm layer
- 15% infill
- 3 walls
- 0 elephant foot compensation
- outer/inner order of walls
The settings are to stop the bottom layer (as it's printed) from coming out slightly smaller and introducing a lip.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)