Crown of the Abyssal Lord

CROWN OF THE ABYSS LORD

Agáres, once a just and benevolent sovereign, now lord of the abyss, was consumed by darkness when his crown of bones subjugated him

This crown, forged from the bones of fallen enemies while defending his kingdom and his people, was imbued with their torment and their thirst for revenge, which has now destroyed the sovereign's mind 

His soul is now trapped in a limbo between life and death, forced to wander his now decaying kingdom for eternity, a living testament to the price of power
 

For this contest, I wanted to create this bone crown, a crown that adorns the head of a character I invented long ago, The Abyss Lord Today with my small A1 mini, I managed to “crown” a dream of mine: to make tangible what until recently lived imprinted in my mind or on some scattered paper sheets in the studio, and now it's here in my hands, or rather, right on my head!!!! 😍

I hope you like it even half as much as I do!!!!

• The crown has been segmented into 4 print plates, where each plate includes one piece (unlike the last plate which includes 2 finished components: SKULL REAR RIGHT and SKULL REAR LEFT) Once each plate is printed and assembled, you can proceed to join the 5 pieces that will form the entire crown
• Alternatively, for larger print plates, I have also uploaded an .STL with the entire crown

🔹If you are interested in selling physical copies of this model, I offer a “Commercial License” on Patreon.🔹

I have not included any assembly guide because you will find everything very intuitive, otherwise do not hesitate to contact me!!!! 😉

For assembly, you will need PLA glue (I use the excellent ARKA - KRAFTPROTZ available on Amazon)

Almost all pieces have interlocking joints that suggest assembly, unlike plates 2 and 3 where component CRANIO LATERO TEMP SX.stl_A and CRANIO LATERO TEMP SX.stl_B will need to be glued together The same applies to components CRANIO LATERO TEMP DX.stl_A and CRANIO LATERO TEMP DX.stl_B

Used eSun PLA+ in “BONE” color

FOR COLORING: Once printed and assembled, I applied multiple coats of “sandy brown” acrylic The paint should be diluted with a lot of water to slightly stain the material, then dab the surface with a napkin to remove excess paint and dry with a hairdryer Repeat the procedure until optimal coloring is achieved 😉

!!!!!!!BEFORE PROCEEDING WITH PRINTING THE CROWN!!!!!!!

>>>VERIFY THE CORRECT SIZE FOR YOUR HEAD WITH THIS PRELIMINARY PRINT<<<

I created this “MEASUREMENT TEST (58cm circumference)” to simplify any resizing of the CROWN and adapt it optimally to any head size and avoid wasting printing material (You will find it as the 2nd print profile or as an .STL file)

Hoping this is helpful, follow the steps below!😉

• Print the TEST and try it on If it is comfortable on the first attempt, you can proceed to print the original CROWN file because it was designed based on that measurement
• If the TEST is too small/large, you need to resize the TEST FILE and re-measure with the resized NEW TEST Once the correct size is found, resize the CROWN with the same percentage used for the NEW TEST