Slot bezel for ATW800/2 VME card

This is a bezel which can be used with the ATW800/2 VME expansion card for the Atari TT and Mega-STE.

It features cut-outs for the HDMI and USB connector(s). 

Each handle (aka “knob”) will be screwed to the bezel using 12mm M2.5 screws.

The bezel itself will also attached to the PCB with two 12mm M2.5 screws and two M2.5 nuts.

All in all, you will need 4x M2.5 screws and 2x M2.5 nuts. This relatively uncommon size is the official VME standard.

• Bezel and knobs can be printed without support. 
• PLA seems to OK so far. PETG or enforced PLA will be more robust.
• Place the bezel face down, knobs standing on their front (i.e. drill-hole facing up)