Milwaukee M12 Gen 3 Impact Bit Holder – Rear Mount

Upgrade your Milwaukee M12 Gen 3 screw gun with this custom-designed bit holder that mounts directly to the back of your tool. This design keeps your most-used bits easily accessible while staying out of the way.

⚠️ Important:

• This print requires five (5) 8mm x 2mm round magnets.
• The print will pause to allow you to insert the magnets before finishing.
• When inserting the magnets during the paused print, use a piece of plastic or something non-metallic to cover each magnet as you place it in. This helps prevent the magnets from snapping together or jumping out of their slots

🔧 Key Features:

• Holds Up to 5 Bits: Provides quick access to your most commonly used bits, securely held in place and easy to grab when needed.
• Magnet-Embedded Base: This bit holder uses 8mm x 2mm round magnets inserted into the base of the print to securely hold your bits in place and allow for easy removal. The print is programmed to pause mid-process, allowing you to insert the magnets before printing resumes for a clean, integrated finish.
• Installation: Simply remove the bottom two screws in the rear of your M12 impact and use those same screws to attach the holder. No additional screws or modifications required.
• Designed to Be Low Profile & Durable: Built for everyday use without adding unnecessary bulk to your tool.

Coming Soon: 

A version designed to hold screws with magnets, as well as a press-fit version that doesn’t require magnets.