Search models, users, collections, and posts
Elephant Battery Dispenser
IP Report
Print Profile(2)
Elephant AA battery dispenser - 0.4mm nozzle, 0.2mm layer, 2 walls, 12% infill, NO brim
Designer
1.7 h
1 plate
elephant AAA battery dispenser, 0.4nozzle, 0.2mm layer, 2 walls, 12% infill, NO brim
Designer
1.4 h
1 plate
Open in Bambu Studio
Boost
26
50
8
2
50
34
Released
Description
Easy to print two pieces battery dispenser.
Just apply some super glue on the marks and hold the pieces together while it dries, and its Done!
The pieces are flat from the bottom, but be sure to keep the piece upright while gluing to avoid any movement left when finished
Recommended settings:
-orientation: same as default, the flat side towards the buildplate
-material: pla, petg
-layer height: 0.2
-supports: NO
this is one member of my original "HomePals" collection that you can see here:
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (8)